Track laying for rail electric transfer cars

The railed transfer car manufacturer said that the electric transfer car track is the foundation road map of the electric transfer car walking, its foundation-laying quality is bad will affect the service life of the electric transfer car and damage to the electric transfer car accessories. 2 to 10 tons of electric transfer car track should choose the national standard P18 track, 11 tons to 20 tons of railed transfer car should choose P24 national standard track, in increasing order to choose various models of the track, but also according to the design of the flat car to choose the non-standard type of track.

Low-voltage electric transfer car track laying should pay attention to do a good job of insulation measures, insulation measures are not in place will cause leakage, short circuit and other faults, causing the supply voltage is unstable, resulting in electric transfer car running distance shortened or limited load, seriously affect the production of enterprises. Battery-powered, cable reel-powered, cable-powered electric transfer car track laying is relatively simple, but the foundation bedding facilities must be done, or electric transfer car track sinking will cause a series of unnecessary losses.

Process of the railed transfer car: The loose concrete and stones inside the reserved holes of the equipment foundation and around the electric transfer car should be removed first, and then the debris inside the reserved holes should be cleaned up, and then the holes should be cleaned up with a small blower. If you encounter any reinforcement leaking out of the reserved holes, you should deal with it in time to ensure that the reinforcement cannot contact the pre-built bolts.

Common sense of maintenance of railed transfer car: electric transfer car can not work for a long time without interruption, so we should stop every two hours to ensure that all its parts can be effectively repaired. When the usage rate is relatively high, the belt loss needs to be checked every other month, and the serious wear and tear should be stopped immediately to replace the belt.

The railed transfer car manufacturers need to give the electric transfer car contact pulley and running bearings at the beginning of each month for oiling operation (is to add lubricating oil la), check the track when loose with the presence of foreign objects. For the electronic control panel of the electric transfer car, it should be cleaned every 2 months, using the specified reagent to remove ash work on the panel. Battery electric transfer car battery every 1 year to check, the voltage is too low to give replacement.